Following are some common failures and maintenance of pillow type cube sugar packing machine:

1. The temperature is too high, the speed is too slow, the outer coating heat resistance is bad, the seal can appear the mark of the coking

The method of maintenance is to adjust the speed, reduce the temperature, and change the film material.

 

2. The knife seat is too high or too low, the packing speed is too fast, the cutting tool will cut into the product when the putter is out of sync with the cutting knife.

The method of maintenance is to reduce the packaging speed and adjust the end sealing parts, so that the center of the sealing knife is in the middle position of the product height.

 

3. The color of the film color is too light, the film drive is skidding, and the color standard tracking is not opened.

The method of repair is to refer to the packaging machine instruction manual and adjust its sensitivity. In the human-computer dialogue interface, the tracking mode is switched to tracking cutting.

 

4. The solid-state broken appliances burn out, the temperature control instrument is damaged, the thermometer cannot control the temperature when the thermocouple is damaged.

The method of maintenance is to replace the power, replace the temperature control instrument and replace the heating body.

 

5. The speed is too fast, the heat seal in the envelope is poor, and the seal can leak or not firm when the temperature is too low.

The method of maintenance is to slow down, raise the temperature and change the film material.

 

6. The air pressure is not correct, the cylinder swing lever is loose, the heating temperature is low, the hot roller is not parallel to the transmission roller.

The method of maintenance is to adjust the parallelism and adjust the temperature and air pressure to tighten it.

 

Also note that the sensor should be inserted before the power supply and the screws are locked. Can not use metal cover and metal container, can not put on the metal surface to press the start button, otherwise will damage the machine; During the working process, you should always touch the surface of the sensor head and check if it is overheating. If you find that the hot stamping should stop heating, then work after cooling. There will be high pressure in the pillow type packaging machine body, the bottom board has electricity, must pay attention to the maintenance, in case of personal danger.